|
While not required, these optional wiring harness kits take the
tedious task of wiring your new Optix gauges and make the job
simple and quick. All Optix series gauges all have a
Molex connector on the rear of the gauge. There is a
factory installed 12" length of wire coming out of the
preinstalled Molex connector. These wires need to be
stripped, lengthened, and connected to their proper source.
The optional wiring kits below simply plug in to the Molex
connector, replacing the factory pigtail entirely. The
wiring harness's have built-in dimmers for each gauge.
This allows for each gauges brightness to be individually
adjusted to suit the drivers preference.
|
