 |
|
Using a 1/8" NPT tap,
tap the hole. Apply a small amount
of anti-seize lubricant to the threads of
the fitting and tighten. Insert the
probe with its nut and ferrule. You
want the tip of the probe to be in the
center of the exhaust flow. Usually
this means that it will need to be
inserted 1 inch past the threads that you
tapped. Tighten the nut no more than 1
full turn past finger tight. Connect
the thermocouple wires to the lead wire
using the supplied nuts and heat
protective sleeves. You will be
connecting the thermocouple to the end of
the lead wire that has a long red lead and
a shorter yellow lead. Weatherpack
connectors simply plug in to one
another. Shown above is the ISSPRO
thermocouple with
Weatherpack connector. |
|
 |
|