Gauge Installation on a 6.0L Ford Powerstroke
| You are on PAGE 1 | ||
| Click on images to enlarge | ||
 |
 |
 |
|
1. Remove the
factory grab handle if equipped |
2. Removal of factory A-Pillar |
3. Temporarily
mount the gauge mount and check for fit |
 |
 |
 |
|
4. Mark
locations for gauge wires |
5. Drill holes for the gauge wires | 6. Check gauge mount for proper fit |
 |
 |
 |
|
7. Check for
gauge fit |
8. Location for
wires and boost tube through firewall |
9. Firewall plug removed |
 |
 |
 |
|
10. Firewall
plug removed. View from engine compartment |
11. Firewall plug with hole drilled |
12. Transmission
Temp. Sender |
 |
 |
 |
|
13. Location for
Tans. Sender on 6.0L 5R110 TorqShift Transmission |
14. Trans.
Sender installed on 6.0L 5R110 TorqShift Transmission |
15. Boost gauge prep |
| << Previous | 1 | 2 | Next >> | ||